Spiral anchor ⌀10 mm

HS-10

  • Anchor diameter: 10 mm
  • Sectional area [mm²]: 13.00
  • Yield strength [MPa]: 474,10
  • Tensile strength [MPa]: 1006.30
  • Modulus – E [GPa]: 143.50

Zaloguj się aby zobaczyć cenę !

Clear

Description

TECHNICAL PARAMETERS:

Anchor diameter: 10 mm
Sectional area [mm²]: 13.00
Yield strength [MPa]: 474,10
Tensile strength [MPa]: 1006.30
Modulus [GPa]: 143.50

APPLICATION:

  • repairing cracks in structural walls made of brick, stone concrete
  • reinforcing of joints between partition walls and structural walls
  • reinforcement of roof attics
  • reinforcement of balcony plates
  • repairing and strengthening lintels, beams, ceilings
  • anchoring of separating wall sheathing layers
  • stabilization of buckling walls
  • reinforcing walls in modern buildings

    ADVANTAGES OF SPIRAL REINFORCEMENT:

  • Increase the load-bearing capacity of walls, columns, girders, beams, slabs, foundations
  • Quick application – no technological interruptions
  • Low invasiveness – application without mess and fuss
  • Cracks do not reappear – high efficiency of the technology
  • Low cost
     
     
     
     
     

Dodaj tu swój tekst nagłówka

Please refer to the table below for the dimensions of the groove for the spiral anchors, together with the approximate mortar consumption for the anchors:

 

 

min. total anchor length (brick / stone / mixed masonry) – 1000 mm

min. total anchor length (concrete) – 600 mm

We cut the anchors to the specified dimensions on request.

For more design suggestions, please refer to the Hammpack Spiral Hammer technical documentation.

Additional information

Length

, ,